Contax SW 2524 - REV A Guia de Instalação descarregar pdf (Página 24)

Installation

1–6 975-0637-01-01 Rev B

This guide for use by qualified personnel only

Conext SW Supplied Accessories

NOTE: If any of the supplied accessories are missing, contact customer service

for replacement. See “Contact Information www.schneider-electric.com” on

page ii.

Figure 1-5 Supplied Accessories

Item Description

1 Two DC terminal covers prevent accidental contact with the DC cable

connectors after installation. The red cover is for the positive cabling

terminal, and the black cover is for the negative cabling terminal.

2 BTS, the Battery Temperature Sensor consists of:

• Connector that plugs into the BTS port on the Conext SW.

• Sensor cable is 7.6 meters.

• Sensor can be mounted on the side of the battery case or on

the negative battery terminal.

NOTE: The BTS continuously measures the temperature of the battery

and adjusts the charger output for a more accurate, temperature-

compensated charge.

3 Two sets of 5/16"-18 nuts and washers are used to secure DC cable

ends to the DC battery terminals.

4 Two Xanbus network terminators are used to properly terminate each of

the two ends of the daisy-chained Xanbus network. For example, if the

SCP is connected to the inverter/charger, one terminator will be

plugged to the SCP, one network cable will connect both devices, and

one terminator will be plugged to the inverter/charger.

IMPORTANT: The SCP may perform erratically if the Xanbus network is

not properly terminated.

5 Installation bracket (not shown)

ConextSWEUROInstallationGuide.book Page 6 Wednesday, December 5, 2012 10:55 AM

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 73 74

Sem comentários

Contax SW 2524 - REV A Guia de Instalação Página 24